2x4x67-3/4" composite sleeves	3
4x4x78" composite sleeves	1 (cut in half) per panel(+ a half per fence end)
Mounting bracket sets	6 total or 3 pairs (sold by the pair)
Post Cap	1 (per 4 X 4 sleeve)
AC2 treated 2x4x6'	3
AC2 treated 4x4x6' post	1 per panel (+ 1 at fence end)

Cut 1 - 78" 4X4 post sleeve in half each piece will be 3' 3" long.

Cut 3 - 2 X 4's and 2 X 4 sleeves to 67 ¾" (For 72" O.C. post spacing) Slide the 2 X 4 sleeves over the 2 X 4 boards until the ends are flush, these will be your backer rails.

Attach brackets to each end of the backer rails.

Measuring from the top of the 3'-3" post sleeve attach the top rail 4" down from the top of the post sleeve to the top edge of the rail. Measuring from the top of the 3'-3" post sleeve attach the middle rail 18" down from the top of the post sleeve to the top edge of the rail. Measuring from the top of the 3'-3" post sleeve attach the bottom rail 32" down from the top of the post sleeve to the top edge of the rail. Using a level check that the rails are level between the 3'-3" & 6'-6" posts.