Learn more
Building A Scalloped Fence Print
Overall Skill Level: Expert
Setup for a Scalloped fence.
Steps
  1. Scalloped Fence
    1. Bracket Installation
    2. 2 X 4 Sleeve Assembly
    3. Preassembling Fence Panel
    4. Attaching Remaining Brackets
    5. Installing Panels Between the Posts
    6. Level Panel and Complete Attachment
Tools
  • Drill
  • Saw
  • Hammer
  • Carpenter's Square
  • Level
Materials
  • 13 72" pickets
  • 3 2x4x67-3/4" composite sleeves
  • 1 4x4x78" composite sleeves + 1 at fence end
  • 6 total or 3 pairs of Mounting bracket sets
  • 1 Post Cap per 4x4 sleeve
  • 78 1-5/8" screws
  • 3 AC2 treated 2x4x6'
  • 1 AC2 treated 4x4x10' post + 1 at fence end
Scalloped Fence
Skill Level: Expert
  1. Bracket Installation
    Center and attach the top brackets, 12" down from the top of the post sleeve to the bottom of the bracket. You can use a string level between brackets to check that they are level. The open end of the bracket needs to face towards the side of the fence that will have pickets.
  2. 2 X 4 Sleeve Assembly
    Cut all 2 X 4's and 2 X 4 sleeves to 67-3/4" (For 72" O.C. post spacing). Slide the 2 X 4 sleeves over the 2 X 4 boards until the ends are flush, these will be your picket backer rails.
  3. Preassembling Fence Panel
    To create the scalloped top effect, you will need to cut the pickets to the following lengths: 2 qty. - 72" (no need to cut as this is the original length), 2 qty. - 71-1/4", 2 qty. - 70-1/2", 2 qty. 69-3/4", 2 qty. - 69", 2 qty. - 68-1/4", and 1 qty. - 67-1/2". On a flat surface position the 3 backer rails parallel to each other spaced 23" apart. Evenly place the pickets across the backer rails, positioning the longest pickets on the outside, and arranging the rest of the pickets in descending size toward the center. Line up each picket so that it is at 90 degree angle to each backer rail and is 6" above the top surface of the upper backer rail for the 2 outer pickets. Working towards the middle of the panel, each picket should be 3/4" lower the previous picket, and all pickets should be even along the bottom of the panel. Using 1-5/8" screws attach pickets to the backer rail, 2 screws into each backer rail (6 screws per picket).
  4. Attaching Remaining Brackets
    Flip the panel over so that the pickets are now facing down. Attach the remaining 4 brackets to the ends of the middle and bottom backer rails.
  5. Installing Panels Between the Posts
    Lift the panel into position between 2 posts and slide into the upper brackets that were previously installed. Fasten the upper brackets to the top backer rail.
  6. Level Panel and Complete Attachment
    Using a level check for vertical plumb alignment of panel and then fasten the remaining brackets to the sides of the post sleeves. Repeat steps 1 through 6 for all remaining fence panels.
Products, materials, techniques, tools, building codes and local regulations are subject to change; therefore, Midwest Manufacturing assumes no liability for omissions, errors or the outcome of any project. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed professional before beginning any project.