Learn more
Cupola Assembly Print
Overall Skill Level: Beginner

This guide provides step by step instructions for assembling your cupola.
Cupola Assembly
Skill Level: Beginner
  1. Layout bottom pieces
    Lay out the six pieces as shown and bend the designated pieces to conform to the pitch of the roof.
  2. Assemble side flashing parts
    Assemble the end pieces as shown with sheet metal screws. The flashing is pre-cut to a 4/12 pitch. Trimming the designated areas may be required for other pitches.
  3. Finish bottom flashing assembly
    Attach the side pieces as shown to complete the flashing assembly.
  4. Corner posts
    Attach corner post trim to cupola by sliding the four trim pieces on the corners of the side assembly.
  5. Connect roof flange
    Once all four sides are connected, turn the base over so the roof connecting flange is up.
  6. Slide in roof sections
    Slide the roof sections into the roof connecting flange of each side assembly.
  7. Attach roof cap
    Screw the roof cap to each of the roof sections using the steel plate provided.
  8. Attach roof connectors
    Slide each roof connector 4-6" at a time until all of the connectors are under the cap.
Products, materials, techniques, tools, building codes and local regulations are subject to change; therefore, Midwest Manufacturing assumes no liability for omissions, errors or the outcome of any project. The reader must always exercise reasonable caution, follow current codes and regulations that may apply, and is urged to consult with a licensed professional before beginning any project.